Re: printing issue January 30, 2017 07:23PM |
Registered: 7 years ago Posts: 181 |
Re: printing issue January 31, 2017 08:11AM |
Registered: 8 years ago Posts: 413 |
Re: printing issue February 03, 2017 07:58AM |
Registered: 7 years ago Posts: 17 |
Re: printing issue February 03, 2017 08:15AM |
Registered: 7 years ago Posts: 17 |
Re: printing issue February 03, 2017 10:42AM |
Registered: 7 years ago Posts: 17 |
Re: printing issue February 03, 2017 10:50AM |
Registered: 7 years ago Posts: 17 |
Quote
Supermec
drwatsont,
what happens to the head, if using the controls on the printer, you tell it to "Home All". If the nozzle ends up just off the front left hand side of the bed then that is where your FIRMWARE thinks is X=0, Y=0, Z=0. The slicer then needs to be set to reflect that. If the nozzle ends up at the centre of the bed then you need to tell the slicer that is where the zero position is and the printing area in the slicer needs to run from a -ve value to a +ve value in both the X and Y directions.[/quote
In slice my settings for the bed is 0,0(when i press home all all axis hit the endstopers,when i press the red button it goes to the middle of the bed)
Re: printing issue February 03, 2017 12:20PM |
Registered: 7 years ago Posts: 181 |
Re: printing issue February 03, 2017 02:47PM |
Registered: 7 years ago Posts: 17 |