Hello,
Im using
electronics : Azteeg x3 V1.1
drivers : TB 6128 (omc.stepperonline)
motorrs : NEMA 23 on 2,4 Amp phase
firmware : Repetier firmware V0.92
host : Repetier host trough usb to board
My problem is that when I print or move freely XY the motors do movement and stepping correctly but when the move ends the motor goes a small bit back, seems to me that the drivers dont hold position correctly. But when I try to move X or Y manualy motor holds it. I tried flashing Marlin ( same problem ) I tried changing drivers for RAPS 128 ( same problem ) I bought a new NEMA 23 ( same problem ). The drivers Im using are having step on low which I set by changing global start_step_with_high in repetier.h
Any help would be apriciated
Thanks
