ABS print lifting December 14, 2016 05:56PM |
Registered: 7 years ago Posts: 9 |
Re: ABS print lifting December 14, 2016 06:02PM |
Registered: 7 years ago Posts: 181 |
Re: ABS print lifting December 14, 2016 06:06PM |
Registered: 11 years ago Posts: 5,780 |
Re: ABS print lifting December 14, 2016 06:54PM |
Registered: 7 years ago Posts: 9 |
Re: ABS print lifting December 14, 2016 07:49PM |
Registered: 10 years ago Posts: 770 |
Re: ABS print lifting December 14, 2016 08:05PM |
Registered: 8 years ago Posts: 1,873 |
Quote
What I don't understand is the fact that all was fine for about an hour then it all went wrong. The bed temp was still the same
Re: ABS print lifting December 14, 2016 11:39PM |
Registered: 8 years ago Posts: 916 |
Re: ABS print lifting December 15, 2016 03:27AM |
Registered: 7 years ago Posts: 9 |
Re: ABS print lifting December 15, 2016 08:38AM |
Registered: 8 years ago Posts: 1,873 |
Quote
TonyPagett
Why would the first 10mm shrink but not the next 12mm?
There is a definite line around the item as if it were printed in two parts.
Below the line has shrunk to 4mm thick in places
Above the line is perfect
By the way, the print is a custom size project box with 2mm thick sides and face with a few added extras for perfboard support etc
Re: ABS print lifting December 15, 2016 11:42AM |
Registered: 7 years ago Posts: 9 |
Re: ABS print lifting December 15, 2016 11:59AM |
Registered: 8 years ago Posts: 1,873 |
Re: ABS print lifting December 15, 2016 12:47PM |
Registered: 7 years ago Posts: 558 |
Re: ABS print lifting December 15, 2016 01:47PM |
Registered: 10 years ago Posts: 770 |
Re: ABS print lifting December 15, 2016 03:47PM |
Registered: 12 years ago Posts: 2,470 |
Re: ABS print lifting December 18, 2016 12:58PM |
Registered: 7 years ago Posts: 9 |
Re: ABS print lifting December 18, 2016 02:26PM |
Registered: 12 years ago Posts: 2,470 |
Re: ABS print lifting December 18, 2016 04:41PM |
Registered: 7 years ago Posts: 9 |