Hello everyone!
I have been having trouble with my hotends on my mendel90 not getting to 230+. I have ran the PID autotune several times via M303S245C10. It has no problem completing the autotune at that temp. but when I go to print at 235-245 (for PETG) my temps. rise to 200 no problem then the speed tapers off fast until it causes a kill printer error. ( I have increased the time in Config_adv.h) I have had this issue with these hotends: E3d V6 (clone), E3d V6 lite, and E3d V6 Volcano.
It is likely user error but anything will help. Thanks!
Azteeg X3
650W 80+ Silver PSU
12v 200W Silicone Heater
E3d V6 lite
E3d V6 Volcano
5 is 100K thermistor - ATC Semitec 104GT-2 (Used in ParCan & J-Head) (4.7k pullup)
#define DEFAULT_Kp 10.32
#define DEFAULT_Ki 2.02
#define DEFAULT_Kd 13.19
#define WATCH_TEMP_PERIOD 35
#define WATCH_TEMP_INCREASE 2