Hey, I need help again!
So I was printing and had to kill the print, the thing is that the fan turned off with the killing and I didn't realize until later. When I realized the top part of the extruder was hot and the filament jammed. So I turned the heat off, waited till it was cold and took the extractor off from the machine. The thing is that to un jam it I need to heat it. Because I can't take out the nozzle with the plastic melted inside. (sorry if it doesn't understand well, I don't really know all the technical names of the parts)
But here comes the problem:
When I try to heat the nozzle, the lcd screen shows that it's not heating and in a few seconds sent the message:
"Printing Failed
PRINTER HALTED
Please Reset"
I tried a few times again and again but its always the same.
Can someone help me with this?