extruder stops only in one part of the print [Solved] November 15, 2016 03:40PM |
Registered: 12 years ago Posts: 32 |
Re: extruder stops only in one part of the print November 15, 2016 04:22PM |
Registered: 10 years ago Posts: 770 |
Re: extruder stops only in one part of the print November 15, 2016 04:30PM |
Registered: 12 years ago Posts: 32 |
Re: extruder stops only in one part of the print November 15, 2016 04:47PM |
Registered: 10 years ago Posts: 770 |
Re: extruder stops only in one part of the print November 15, 2016 06:08PM |
Registered: 10 years ago Posts: 651 |
Re: extruder stops only in one part of the print November 16, 2016 12:28AM |
Registered: 12 years ago Posts: 32 |
checked is not skipping or slippingQuote
Floyd
Check and make sure your filament is being fed evenly and not skipping or slipping on the motor shaft.
no is not, it is at the half partQuote
FA-MAS
Also is that the start of that loop?
is not doing a retract.Quote
FA-MAS
Edit, looking at the skirt back there, if that lifted part is the end of it, looks like it moved and retracted a lot, quickly. Probably too far. Check the retraction speed and distance.
Re: extruder stops only in one part of the print November 16, 2016 07:16AM |
Registered: 11 years ago Posts: 5,780 |
Re: extruder stops only in one part of the print November 16, 2016 02:13PM |
Registered: 12 years ago Posts: 32 |
that was indeed the cause, thank you!Quote
the_digital_dentist
I see two areas where extrusion failed- were they along the X axis or the Y axis when you printed the part? If they were along the X axis, I think you have an intermittent wire going to the extruder motor. Can you post a few pictures of the printer?
The extruder carriage moves a lot so the wires connecting to it bend a lot. If the radius of the bend is too small, the wires can break inside their insulation and intermittently connect and disconnect, depending on the position of the extruder along the X axis.
I will, I didn't noticed pops up or garbage pages because with Tirisquel and abrowser I did not had any pop up. Sorry for that!Quote
the_digital_dentist
In the future, upload video to youtube or vimeo. The site you used pops up all sorts of garbage pages. I didn't actually get to see the video because of that crap.