Guys i am getting this error during print . I think it is related to slic3r as i have two identical mendels with different bed sizes. My opinion was that if i switch from the one to another and load a stl file without restarting slic3r with the proper settings ( the printer that will do the job) then i am getting this results always. The last two months i was very carefull not to load stl before i restart and prints were ok . But today i did it and see what happened.
I am not sure though that this is the cause . My belt is ok and the table do all the y move smooth enough . But i could use some advice to troubleshoot the problem.
Here are some photos.
Delta Printer
Duet 0.8.5 firmware 1.19