Wholes in my print

I've been waiting about a month for a new nozzle cause my older one was seriously clogged, and I also received a new PLA filament. I started printing and it seems as air bubbles get in the nozzle and make these gaps. I am certain it is not clogged because the filament flows out by its own. ?!
Please help me for a better print quality…

Few things that you can do:

Lower your temperature: 190 - 195 for PLA.

The printed fan duct looks quite small and don't think is pulling enough air volume.

Slow your printing speed so the layers have time to cool before the next one is layered.

Use random start point for the layers.

Thank you! I'll try that. "The printed fan duct looks quite small and doesn't think is pulling enough air volume.
" Yes, I do think the fan is not sucking much in. Thanks again.

I turn the temperature down from 210C° to 190C° and it's perfect!!! Thanks