Bridging not adhering when using Slic3r October 18, 2016 04:13PM |
Registered: 7 years ago Posts: 3 |
Re: Bridging not adhering when using Slic3r October 18, 2016 04:24PM |
Registered: 10 years ago Posts: 770 |
Re: Bridging not adhering when using Slic3r October 18, 2016 06:30PM |
Registered: 10 years ago Posts: 651 |
Re: Bridging not adhering when using Slic3r October 19, 2016 02:04AM |
Registered: 7 years ago Posts: 3 |
Quote
FA-MAS
Slic3r 1.2.7 seems to slice it fine, maybe you're running on an older version that does it differently?
I do notice that it does a thicker inner perimeter for the bridging section though.
[attachment 85074 duct.jpg]
Re: Bridging not adhering when using Slic3r October 19, 2016 07:43AM |
Registered: 8 years ago Posts: 413 |
Re: Bridging not adhering when using Slic3r October 19, 2016 07:51AM |
Registered: 7 years ago Posts: 3 |
Quote
MCcarman
Just wondering why Slicer is showing 3 perimeters and cura 2.
So this may be down to what settings you are using in each program.
Re: Bridging not adhering when using Slic3r October 19, 2016 11:26AM |
Registered: 10 years ago Posts: 651 |