I'm running Repetier under Pronterface on a RAMPS 1.4 control board.
Using the 'home all axes' button on the control interface in pronterface causes the printer to home all axes upwards and verify, as expected.
Therefore, all the motors, endstops etc are correctly wired and functioning. I have checked baudrates, which are 115200
Trouble is the printer ignores all commands sent via the command line. The output is as follows:
">>> G91
SENDING:G91
ok 0
>>> G1 Z-20
SENDING:G1 Z-20
ok 0
X:0.00 Y:0.00 Z:120.00 E:0.00"
The same issues happen in Repetier-Host.
1) It always responds to home commands sent via the interface,
2) It never responds to axis movement commands sent via the interface
3) It never responds to any commands sent via the command line (except if you send a command before homing, and then only M codes not G codes)
What have I forgotten to check?
