1- The slicers are all making bad gcode (unlikely) Check by reading the gcode to see if anything looks wrong where it goes wrong.
2- Electrical interference, bad usb cable, cables are too long or routed badly for the lcd, flakey sd card. For the usb, try another cable or a different usb port on the computer. One pc that I have, the MEGA won't program with USB3, but the USB2 ports work fine. For the LCD re-route the cables or make them shorter. Cables longer than 10" can cause problems if they're not shielded. For the sd card, do a fresh format or try a different one.