has anyone found a way to prevent the ooze from sticking to the model with a chimera?
so far I've managed to minimized the mess to almost a clean print by increasing the retraction speed to 50mm/s at 16mm retraction at 185c, any lower on temp I end up with under extrusion unless maybe I lower the print speed, which isn't ideal
ooze is not really a solution to this as it mostly get dragged over to the model after certain height
all things I've tried I was using cura in repetier host
I will try sli3er tomorrow with skirt at same height as the model and see how that goes
any suggestions?