I am trying to print a cable chain similar to this one here:
[
www.thingiverse.com]
Unfortunately, the prints aren't coming out too well as you can see here:
I am printing PLA at about 190C and I have a fan blowing from the front of the hot end toward the back of the print bed. The parts are oriented with the curved portion toward the back of the print bed as well.
Print speed is 50mm/sec and everything else is set at 30mm/sec.
I checked the belt tension and it seems ok to me. Any ideas/suggestions? One that comes to mind after writing this is to try printing it with the curved part toward the front of the bed and/or sideways to see what effect I get.