New heat block. What changed? June 07, 2016 01:06AM |
Registered: 8 years ago Posts: 116 |
Re: New heat block. What changed? June 07, 2016 02:55AM |
Registered: 12 years ago Posts: 2,470 |
Re: New heat block. What changed? June 07, 2016 07:42AM |
Registered: 10 years ago Posts: 1,401 |
Re: New heat block. What changed? June 07, 2016 07:56AM |
Registered: 8 years ago Posts: 116 |
Re: New heat block. What changed? June 09, 2016 03:20PM |
Registered: 8 years ago Posts: 32 |
Re: New heat block. What changed? June 09, 2016 07:02PM |
Registered: 8 years ago Posts: 116 |
Re: New heat block. What changed? June 14, 2016 08:54AM |
Registered: 8 years ago Posts: 15 |
Re: New heat block. What changed? June 14, 2016 09:04AM |
Registered: 8 years ago Posts: 116 |
Re: New heat block. What changed? June 14, 2016 10:14AM |
Registered: 8 years ago Posts: 15 |
Quote
hoxsiew
I did have to pull the thermistor out of the old block through a birds nest of filament and worried that I might have damaged the leads, but it seems OK and give reasonable values on temperature.
I think I've since figured it out and, as suggested earlier in the thread, it seems to have been the nozzle. I soaked my old one in acetone (took 3 or 4 days to fully dissolve the ABS), then installed it into the new block. It's making good prints again.
Thanks to Srek and ggherbaz for suggesting the nozzle.
Re: New heat block. What changed? June 14, 2016 09:23PM |
Registered: 9 years ago Posts: 1,873 |
Re: New heat block. What changed? June 14, 2016 10:03PM |
Registered: 8 years ago Posts: 116 |
Re: New heat block. What changed? June 15, 2016 05:54AM |
Registered: 9 years ago Posts: 1,873 |