[Presentation][Warning] Warning: Seems like we missed a ok, got a wait - continue sending.

Hello,
My name is Mariano, i have a variant of P3Steel, RAMPS 1.4, MK8 extruder w/Heated bed.

I'm using Repetier Firmware (v0.92) and Host (V1.6.1) running on linux (lubuntu 64Bits) at 115200 baud and sometimes when conection is idle i receive repeteadly this message:

xx:xx:xx.xxx : Warning: Seems like we missed a ok, got a wait - continue sending.

I'm new, and trying to set my printer ready. Have never print something longer than half an hour and didn't realize it was a problem at printing time.

What does it means?

Any ideas?

Thank you

Usually this error indicates buffer or com port problems.
You can try to check the settings and/or use a shorter USB cable with ferrite filters.
There is also plenty of discussion about this error in the repetier forums/blogs but (at least for me) without a definate answer to the problem, although I did not search too long...

I am using a USB prolongation cable. So, maybe thats the reason.

Same problem, everithing is OK with a short cable.
With a prologation, the "ok" are missed after 1 minute of the beginning of the print.