I started 3d printing about 3 weeks ago.
im using delta type 3d printer
but some issues here
im using 100mmx100mmx50mm model to calibrate(i need to print large things, and i pause 5~10mm high)
i didnt noticed when i was printing some small 25mmx25mmx25mm thing to calibrate
but when i printer large one its not 90 degree sqaure, its like slightly diamond shaped
and x-axis is spot on 100mm but y-axis is 1mm bigger than x-axis (z-axis is always spot on)
i did measure all parts, assembly
every things fine also marlin config's fine.
but i cant figure out whats wrong
is there any solution for this problem? any one had this problem?
i use simplyfy3d for slicer
thanks
Edited 1 time(s). Last edit at 04/20/2016 07:11AM by secp.
