Part of long 3d model not being printed.

Hi guys,

I solved the issue, but i will explain what happend.

A part of my 3d model ( 19.5 cm model) wasn't being printed, i figured i had the firmware configured to only 20 cm travel and then it just prints the object till it reaches 20cm and ignores the rest of the model ( it does close the part so if you dont know the model you can't see anything is going wrong).

Cheers

Edited 6 time(s). Last edit at 04/14/2016 10:48PM by Govahnator.

It should not come out the same when you turn it.
Otherwise I would have said the stepping for one axis is off.