Next problem! Auto Leveling....

Hi AGAIN!

I completed my Auto leveling on my i3 and it works great! as far as the FW goes...
Apart from when I give it the G29 command....
The Z axis drives down and it lowers the servo too low and the lowest corner crashes into the build plate..... That is, the Z is too low before the switch can get level with the build plate...
Any suggestions???

It homes ok with the G28 and even after a little extra height in Z, the Z motors drive down before lowering the Z servo???

All the Z_RAISE_BEFORE_???? need to be more than the Z_PROBE_OFFSET_FROM_EXTRUDER. For example, z offset is -14, then both z raise before need to be at least 14 plus a little to clear the switch.

Yep! That was it... I just figured it out...
Thank you....