Hi everybody,
Just got my 3d Delta together and after a couple of issues with the motherboard it's working. Well kind off...
First, while my calibration is right the printing starts 7mm above the tray.
Then, the printer is obviously not doing the work, barely moving aside or up when it should (
i'm trying to print the banner) and the printing time goes from 20mn to 0 in 2mn.
I'm working on repetier 1.6 and by the manual my settings are rights, especially the printing speed set in "slow".
I don't get it, so if you do thanks for your help.
Edited 1 time(s). Last edit at 11/21/2015 06:06PM by T3D.