Need a lot of force to push filament November 10, 2015 11:57AM |
Registered: 8 years ago Posts: 6 |
Re: Need a lot of force to push filament November 10, 2015 12:34PM |
Registered: 8 years ago Posts: 430 |
Re: Need a lot of force to push filament November 10, 2015 12:59PM |
Registered: 8 years ago Posts: 6 |
Re: Need a lot of force to push filament November 10, 2015 02:27PM |
Registered: 8 years ago Posts: 430 |
Re: Need a lot of force to push filament November 10, 2015 03:00PM |
Registered: 9 years ago Posts: 569 |
Re: Need a lot of force to push filament November 11, 2015 12:59AM |
Registered: 8 years ago Posts: 6 |
Re: Need a lot of force to push filament November 11, 2015 01:00AM |
Registered: 8 years ago Posts: 6 |
I tried to drill the nozzle , cleared , but still hard to extrude it .Quote
Kurzaa
Nozzle might not be jammed, but their could still be a small piece of containament partially blocking in, requiring more force to extrude the filament. Try doing a couple of cold pulls (?) to clean out anything that might be in the nozzle. Or if you already have it off, maybe bake it in the oven or something, dip it in acetone over night? Just throwing out ideas.
Re: Need a lot of force to push filament November 11, 2015 01:09AM |
Registered: 8 years ago Posts: 6 |
Quote
jiuntian
I will try test the tempereture later .Quote
msaeger
That sounds like a clogged nozzle or not hot enough. Maybe there is a issue with the thermistor or something else making it not report the right temp.