Welcome! Log In Create A New Profile

Zprobe calibration with proximity induction probe

Posted by pazza

pazza

Zprobe calibration with proximity induction probe
October 18, 2015 11:30PM

Registered: 8 years ago
Posts: 15

hi guys i got a kossel printer with ramps 1.4 rich marlin 1.04 .

i need help in sorting out the reason why my zprobe ( proximity induction probe) dose a mid air probe when i do either a G30 A ot G29

help would sooo be greatly apprieciated

Reply Quote

epicepee

Re: Zprobe calibration with proximity induction probe
November 09, 2015 12:33PM

Registered: 11 years ago
Posts: 471

Check the endstop statuses when the effector is in the air, see if it's triggered.

Reply Quote

deaconfrost

Re: Zprobe calibration with proximity induction probe
November 09, 2015 01:08PM

Registered: 8 years ago
Posts: 310

try lowering the z close to the bed then do a g30 or g29 and see if it probes the bed. I seen that happen before

Reply Quote

nesthaesis

Re: Zprobe calibration with proximity induction probe
November 14, 2015 02:02PM

Registered: 8 years ago
Posts: 5

How much " mid air " are we talking about ? These proximity sensors turn on within 2-4 milimeter.