I have a Folgertech Kossel 2020 printer and tried to fix an issue I was having with printing high after I switched my servo motor.
I went through some steps as shown in this video
Manual Delta Calibration using M665 and M666. I also used the following command M206 but I went wrong somewhere in the video. Now when I use the command M501 it shows my Z as 247.70 which is the height of my Z but not sure if this value is supposed to be set as my 206 Z. So, with that being said if I check the Z using M114 that value now comes up as 495.40 which is double of what the value in command M206 is.
I know this is not correct so what value should be under command M206 and M665?
I even went to the extent of reflashing the firmware that was provided with my printer but when I check the values under M114. It ends coming back to the same 495.40 value even though I added the correct Z height in my firmware.