Good prints gone bad
Posted by Koby_88
|
Good prints gone bad September 20, 2015 10:07AM |
Registered: 8 years ago Posts: 26 |
Hi to all, my prusa i3 start acting really weird lately. Prints are ok but finish is bad, it looks like under extrusion but always in same pattern. I try to increase and decrease my e steps but always with same result... I hope someone can help me.
|
Re: Good prints gone bad September 20, 2015 07:37PM |
Registered: 8 years ago Posts: 778 |
|
Re: Good prints gone bad September 21, 2015 06:39AM |
Registered: 9 years ago Posts: 752 |
|
Re: Good prints gone bad September 21, 2015 06:54AM |
Registered: 10 years ago Posts: 14,672 |
Quote
Downunder35m
either your infill is too low or you are not using enough solid top layers.
+1 for this reply.
Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod
Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].
|
Re: Good prints gone bad September 23, 2015 02:56PM |
Registered: 8 years ago Posts: 26 |
On pictures i provide my infill was 15% and 2 perimeters and 2 top layers, i try to increase my perimeters and solid layers to 4 and 30% infill and it looks much better but problem is steel there... I think problem could be in crappy Chinese bearings what do you think could that be the reason ?
Sorry, only registered users may post in this forum.