I've just fixed some issues with my printer's stepper motors and after a few calibration prints, I tried to print out a real design, however, multiple problems occurred after the first few layers. As you can see in the attached photos, there is missing infill, small beads instead of lines that cover the perimeters, and slight offset of layers. Anyone know what's causing these problems? Thanks!
My usual prints are perfectly aligned with straight perimeters, no problems whatsoever, so I'm curious as to why there is a sudden change, could it be from motor current or extrusion speeds?
Edited 1 time(s). Last edit at 09/03/2015 04:11AM by 4Lyfe.