Hello. I've previously asked this on the Repetier category, but I'd like some insight from others as to what may be the problem. So:
I'm using a Rostock (delta) printer running Repetier Firmware, controlled by Repetier host.
The extruder stepper refuses to move in manual control and in print mode.
I know that the extruder stepper and driver work, when exchanged with one of the axis steppers it worked properly.
I've tried this with the extruder cold and hot, no difference.
As far as I know, Configuration.h is properly set up.
I've tried plugging the stepper and driver into the E1 slot instead of E0, did not work.
EEPROM is disabled due to it causing some problems in the past
Any suggestions?