Changed to slic3r 1.29 and bulge in prints? *resolved*
Posted by Layerz
|
Changed to slic3r 1.29 and bulge in prints? *resolved* July 18, 2015 02:32PM |
Registered: 8 years ago Posts: 18 |
Hoping for some insight on the magic option on this one, I've attached pics of the prints and settings below.
When I print using repetier and cura engine things are fine albeit a little squashed. Switching to Slic3r 1.29 I get bulges and the infill when I watch it print is super high even though I have turned it down as low as 5%.
Hopefully as I mentioned there is a glaring setting or something that I am missing with this.
Resolved per below post, it was the Solid infill threshold area being set really high
Edited 1 time(s). Last edit at 07/19/2015 12:34PM by Layerz.
When I print using repetier and cura engine things are fine albeit a little squashed. Switching to Slic3r 1.29 I get bulges and the infill when I watch it print is super high even though I have turned it down as low as 5%.
Hopefully as I mentioned there is a glaring setting or something that I am missing with this.
Resolved per below post, it was the Solid infill threshold area being set really high
Edited 1 time(s). Last edit at 07/19/2015 12:34PM by Layerz.
|
Re: Changed to slic3r 1.29 and bulge in prints? July 18, 2015 03:43PM |
Registered: 8 years ago Posts: 778 |
|
Re: Changed to slic3r 1.29 and bulge in prints? July 18, 2015 04:56PM |
Registered: 8 years ago Posts: 18 |
|
Re: Changed to slic3r 1.29 and bulge in prints? July 18, 2015 07:18PM |
Registered: 9 years ago Posts: 752 |
Maybe you've accidentally abled presxure management. It's an experimental feature. Try turning it off and see if it improve your print. You can turn on extrusion width simulation in repetier host, you'll usually see the over extrusion clearly.
Edited 1 time(s). Last edit at 07/18/2015 07:18PM by imqqmi.
Edited 1 time(s). Last edit at 07/18/2015 07:18PM by imqqmi.
|
Re: Changed to slic3r 1.29 and bulge in prints? July 19, 2015 12:34PM |
Registered: 8 years ago Posts: 18 |
Sorry, only registered users may post in this forum.