Another Print Assessment
Posted by Kafledelius
|
Another Print Assessment June 30, 2015 01:36AM |
Hello Reprappers!
So i built my own I3, and i have it calibrated and its printing fairly good (To my own opinion).
But now i am looking for guidance towards further optimizations of my printer.
I have attatched some pictures of a print i made of Emmets screwless Cube gears.
Would you guys have a look and maybe give me some pointers to what you think i can optimize?
The Print is done at 0.2mm Layer height, 80mm/s and an infill of 30% with 4 perimeters.
Edited 1 time(s). Last edit at 06/30/2015 01:38AM by Kafledelius.
So i built my own I3, and i have it calibrated and its printing fairly good (To my own opinion).
But now i am looking for guidance towards further optimizations of my printer.
I have attatched some pictures of a print i made of Emmets screwless Cube gears.
Would you guys have a look and maybe give me some pointers to what you think i can optimize?
The Print is done at 0.2mm Layer height, 80mm/s and an infill of 30% with 4 perimeters.
Edited 1 time(s). Last edit at 06/30/2015 01:38AM by Kafledelius.
Sorry, only registered users may post in this forum.