I'm not really wizz enough to do this, I'm sure some of you are.
A useful thread to have would be as per title to expand on the triffid hunter page. Maybe included as part of the 'print issue identifier' wiki
I don't mean the obvious mechanical calibrations like steps per mm.
I'm thinking retraction, acceleration, jerk, cooling. What else?
I appreciate a lot of settings impact on one another, but what would be useful would be a stock set of small test print objects to fine tune each variable specifically and intelligent interpretation of the results.
With pictures.
ie Retraction would be a print of a group of small towers, say, to show stringing between them for under retraction. I know it's awkward as it's influenced by nozzle temp, and material too.
I know the info is floating about, and these things are forever cropping up in this 'Printing' forum.
Any volunteers to nail it down into a single document?
With pictures!
-a
