Can anyone help me figure out why my extruder is skipping like this? May 09, 2015 02:23PM |
Registered: 8 years ago Posts: 15 |
Re: Can anyone help me figure out why my extruder is skipping like this? May 09, 2015 03:48PM |
Registered: 11 years ago Posts: 1,320 |
Re: Can anyone help me figure out why my extruder is skipping like this? May 09, 2015 06:25PM |
Registered: 8 years ago Posts: 15 |
Quote
jbernardis
it's not filament slipping because the shaft of the motor is twitching too. To me it looks like you need to adjust your stepper driver current. It looks like it might be a bit low. I don't know anything about your electronics, but the typical stepper driver has a trimpot which you can use to adjust this.
Re: Can anyone help me figure out why my extruder is skipping like this? May 09, 2015 07:04PM |
Registered: 8 years ago Posts: 15 |
Re: Can anyone help me figure out why my extruder is skipping like this? May 10, 2015 01:46PM |
Registered: 9 years ago Posts: 182 |
Re: Can anyone help me figure out why my extruder is skipping like this? May 10, 2015 02:33PM |
Registered: 8 years ago Posts: 15 |
Re: Can anyone help me figure out why my extruder is skipping like this? May 10, 2015 08:06PM |
Registered: 11 years ago Posts: 1,171 |