Good morning,
so, I just received my Geckotek 3D Buildplate from the kickstarter campaign:
link
I got the entire weekend to test this plate. Unfortunately even on small parts, I've a massive warping on the prints. I tried different Z offset settings. From zero (nozzle is directly on the plate) to 0.3 (there is to much space)
It's just feeling like printing on naked glas instead of an special buildplate. Did someone share my experiences? Or does someone has tipps for me? I'm only printing PLA.
(p.s. Yes, the bed is leveled correctly)
Thanks in advance for your suggestions.