Welcome!
Log In
Create A New Profile
Home
>
Printing
> Topic
Advanced
excruder is printing on the edge of the bed
Posted by
laurav867
Forum List
Message List
New Topic
laurav867
excruder is printing on the edge of the bed
March 12, 2015 08:25PM
Registered: 9 years ago
Posts: 1
when I go to print it prints on the edge of the heat plate. Can any one tell me how to adjust it to print closer to the middle of the heat plate?
Reply
Quote
Ohmarinus
Re: excruder is printing on the edge of the bed
March 12, 2015 09:11PM
Admin
Registered: 11 years ago
Posts: 3,096
Hello, maybe your endstop is not in the correct position?
Can you adjust your endstop?
http://www.marinusdebeer.nl/
Reply
Quote
KingRahl
Re: excruder is printing on the edge of the bed
March 12, 2015 10:33PM
Registered: 10 years ago
Posts: 241
If it is printing a straight line, it sounds like an endstop is not attached properly. Probably for the X axis. Check your wires, soldering, and plug for proper connection.
Reply
Quote
jbernardis
Re: excruder is printing on the edge of the bed
March 13, 2015 12:01AM
Registered: 11 years ago
Posts: 1,320
You also have to set the center of your build area in your slicer. You didn't give us any details, so it's hard to know.
Reply
Quote
Newer Topic
Older Topic
Print View
RSS
Sorry, only registered users may post in this forum.
Click here to login