filament

im running a prusa i3 with 1.7amp 17 stepper motors on ramps with marlin and a e3d v6 hotend

now this is the first reel of 3mm pla ive bought and its a tight fit into my hotend it takes some force to push it into the hot end it this right are if my filament junk

Are you sure you shouldn't be using 1.75mm filament

this is what i bought and its great

[e3d-online.com]

i just put my pla in the oven for about an hour at 85c and i wrapped my spool but after my pla cooled down for anther hour it now works much better and i cut off the top rap of it and all is good

lesson learned no more buy cheep pla from ebay

i did buy a multi try different colour abs from ridid.ink and its great feels and looks much better