Welcome! Log In Create A New Profile

I have a feeling this is Cura settings issues and not the printer?

Posted by rew632

Forum List Message List New Topic

rew632

I have a feeling this is Cura settings issues and not the printer?
January 06, 2015 09:34PM

Registered: 9 years ago
Posts: 2

Hello everyone smiling smiley

I got a 3d printer kit for my christmas and have it up and running pretty good for a 1st timer but as always its a hobby for me so I will spend hours and hours and plenty of £££ fixing it and playing about with it lol so I hope to get to know you all smiling smiley

Ok this is a problem I only seem to have on the top layer / infill for some reason??? The printer prints very nicely (IMO) until it attempts to make fill or flat top on an object. Any help would be much appreciated smiling smiley

Kevin

Some pics:

Reply Quote

Attachments:
open | download - IMG_20150107_021442940.jpg (211.9 KB)
open | download - IMG_20150107_021507006.jpg (199.5 KB)
open | download - IMG_20150107_021517286.jpg (234.2 KB)
open | download - IMG_20150107_021538850.jpg (210.5 KB)
open | download - cura.jpg (338.2 KB)

Arakon

Re: I have a feeling this is Cura settings issues and not the printer?
January 07, 2015 05:28AM

Registered: 9 years ago
Posts: 157

Your bottom/top thickness is way too low. That's basically just a single layer. Try setting it to 0.8 mm.

Reply Quote

rew632

Re: I have a feeling this is Cura settings issues and not the printer?
January 07, 2015 04:22PM

Registered: 9 years ago
Posts: 2

Thanks will give it a go smiling smiley