Hello Everyone,
I have a problem with small marvin keyring object. I have been trying many setups, but none of them didn't work yet.
As you can see the pictures, some layers are going up, so it causes bad part.
I'm using esun ABS Black
100micron layer height
5 perimeters
%25 infill
20mm/s print speed
230degree hot end temperature, 100 degree bed temperature
I tried both slic3r and cura. Cura seems to be good. I have been searching the problem but i didn't find similar like that. I quess there is sagging problem, Am i wrong?
Thank you for any suggestions.
Edited 1 time(s). Last edit at 01/04/2015 10:02PM by RDEng.
Custom 3D Printer,
Mechanical Engineer