Hope i am i the right sub-forum.
I still new anf havend done any REAL calibration of my Pruse I3 other then bed leveling...
Yesterday i will try a square or a part of it, ie 2 side,, i design it as 12.5mm high and whit 0.4mm side,, but it come out
as show on the drawning..
Any idea if ie the extruder giving to much output, i allso wonder about Y side is 0,1mm thitker then X side??
Stranges since i do use a 0,4mm extruder head..
Tommy
Edited 2 time(s). Last edit at 12/31/2014 10:07AM by TommyF.
BQ I3 prusa - PLA