Strange slicing of support
Posted by Walther
|
Strange slicing of support November 11, 2014 02:01PM |
Hi,
I have been trying to slice the Reindog on thingiverse, but both Slic3r and Cura makes weird supports.
In the attached image, Cura makes a large gap in the support, and start the support of the ears in mid air.
Which slicer do you use ?
Thank you,
I have been trying to slice the Reindog on thingiverse, but both Slic3r and Cura makes weird supports.
In the attached image, Cura makes a large gap in the support, and start the support of the ears in mid air.
Which slicer do you use ?
Thank you,
Sorry, only registered users may post in this forum.