Hi all,
I have a Prusa i3 printer.
When i try to print, the Y axis stops and the X axis goes normally and the result is a straight line, then the Y axis move a little bit and again a straight line.
The first move is the same every time no matter what i print and then it seems like Y axis gets stuck randomly with clicks and bumps.
Plus, when i try the manual mode every thing move well except when i start with Y home. then the command doesnt happen.
I tried:
1. Replacing the motor driver.
2. Switching X and Y axis motors and end-stops.
3. Re uploading the Firmware.
4. Update the Driver.
5. Re installed Repetier host.
6. Use another printing software.
7. Checked the end-stops.
8. Checked the driver potentiometer voltage.
I dont know what more to do...Hi all,
I have a Prusa printer.
When i try to print, the Y axis stops and the X axis goes normally and the result is a straight line, then the Y axis move a little bit and again a straight line.
The first move is the same every time no matter what i print and then it seems like Y axis gets stuck randomly with clicks and bumps.
Plus, when i try the manual mode every thing move well except when i start with Y home. then the command doesnt happen.
I tried:
1. Replacing the motor driver.
2. Switching X and Y axis motors and end-stops.
3. Re uploading the Firmware.
4. Update the Driver.
5. Re installed Repetier host.
6. Use another printing software.
7. Checked the end-stops.
8. Checked the driver potentiometer voltage.
I dont know what more to do...