Hello.as shown in picture i have some problem with printer. This is my 6 or7th printer but never before with problem like this.?
My printed line is not straight but goes micro zig zag motion. This happened after rewiring printer with new installation,so all components are fine. I assume that i have some problem with installation but cant figure where. It is noticeable on both x and y axis. I run ramps with 4988
Any ideas
Edited 1 time(s). Last edit at 10/27/2014 06:49PM by woo.
Attachments:
open |
download -
20141027_231103~2.jpg
(306.2 KB)