Repetier Temperature Override

Hello All. I've recently switched from Pronterface to Repetier and everything seems to be going well, except for that whenver I start printing, the program automatically sets the hotend temp to 200C, regardless of where I set it initially (235C). This temp is too low to print ABS, so I'm pretty sol. Anybody else experienced this? Thanks!

The temperature setting is determined by the gcode, not Repetier Host. What slicer are you using? You should check your settings there to make sure it's setting the proper temperature for printing.

Repetier will let you set the temperature for manually heating up the hot end. That's configurable in the settings. But that's not the temperature that will be used for printing.

Yeah I checked the G-Code and it was a problem with the slicer (Slic3er, btw). Easily fixed. Thanks!!