Hello guys,
the attached photo showed a part of vica printed from a kossel like printer. Two kinds of surface defects can be observed, which I marked on photo as A groove and B blob.
Here are some observations:
A Groove, groove happens when nozzle finished parameter and starts to move in to paint infil, it drags ipart of the parameter around the end point towards inside together.
I was thinking, maybe draw parameter first will help, but would like to hear more suggestions.
B Blob, not sure this is typical or not, please excuse me if it has been asked million times. It happens where nozzle lands after a jump. I can't be sure it happens before or during restart, but it accumulates every layer.
let's discuss and find a way to get rid of these scars on surface. thanks in advance
