Hi there
My 3D printer is here: [
www.aliexpress.com]
Basically I have used the default calibration setting but every time i try to print my 3d model, the platform tries to go the wrong way and continually bags into the side of the printer. Also the exstruder just goes up near the top and doesn't come down when trying to print. It just seems the calibration is all wrong. I even tried to set the Control panel settings to 0,0,0,0 but then sent it the other way and did that same thing. What do i do? Im not the most technical of people, so sorry if i sound a bit confusing.