Hello
This is my first post and I have a question. I searched multiple times but can't find an answer.It looks like the motors skipping steps. I see an acceleration when the nozzle goes around the corner and when I look at the extruder I see the same acceleration. I have 2 printers: prusa i3 marlin and a large 3dr running on repetier firmware. Both printers have the same issues. Normal prints are fine but when printing detailt single wal pieces this problem exists.
By the way don't look at the first layers stil calibrating teh 3dr.
Greetings Dirk
Attachments:
open |
download -
WP_20140417_10_11_53_Pro.jpg
(63.8 KB)
