ABS Print
Posted by Osios
Issue printing ABS, not 100% sure what it is smaller prints come out fine, larger prints run into problems.... I made an enclosure to help trap the heat, which helped with some delamination problems I was having used glue stick
which worked pretty good, will probably use abs juice in the future though
ABS
nozzle: 245
bed: 110
layer height: 0.1
using E3D Hotend 0.4
which worked pretty good, will probably use abs juice in the future though
ABS
nozzle: 245
bed: 110
layer height: 0.1
using E3D Hotend 0.4
|
Re: ABS Print April 10, 2014 04:30AM |
Registered: 10 years ago Posts: 18 |
|
Re: ABS Print April 10, 2014 08:21AM |
Registered: 10 years ago Posts: 100 |
|
Re: ABS Print April 11, 2014 03:14AM |
Registered: 10 years ago Posts: 18 |
|
Re: ABS Print April 11, 2014 03:25AM |
Registered: 10 years ago Posts: 100 |
|
Re: ABS Print April 11, 2014 10:38PM |
Registered: 10 years ago Posts: 18 |
I was printing at 245, attempting to get better bonding between the layers, due to issues with delamination, I was able to print at 225 with an enclosure with good layer adherence, lower the extrusion multiplier from 1.0 to 0.9 and print quality improved a lot, still have some tweaking to do, but its a step in the right direction
|
Re: ABS Print April 13, 2014 05:34PM |
Registered: 10 years ago Posts: 13 |
|
Re: ABS Print May 05, 2014 09:53AM |
Registered: 11 years ago Posts: 34 |
Sorry, only registered users may post in this forum.