AZTeeg X3 Pro Stepper skipping February 21, 2014 11:39PM |
Registered: 10 years ago Posts: 3 |
Re: AZTeeg X3 Pro Stepper skipping February 22, 2014 04:38PM |
Registered: 10 years ago Posts: 3 |
Re: AZTeeg X3 Pro Stepper skipping March 25, 2014 12:54AM |
Registered: 10 years ago Posts: 75 |
Re: AZTeeg X3 Pro Stepper skipping March 25, 2014 09:08AM |
Registered: 10 years ago Posts: 23 |
Quote
jhenak
Ok, I finally found out what my problem was.
I didn't have a fan plugged in to FAN_PIN but it was defined as pin 6. I stumbled upon this after finding out that CURA had the Fan cooling setting which adds a line in the GCode to turn on the fan at 50% power.
I updated my firmware to remove the FAN Pin's and it's back to printing.
I have to say that the AZTeeg X3 pro is a nice board, but it seems to make a lot more noise than the RUMBA with the same motors, psu, and stepper drivers.