First layer / callibration issue (Prusa i3 - Slic3r) August 16, 2013 04:01PM |
Registered: 10 years ago Posts: 13 |
Re: First layer / callibration issue (Prusa i3 - Slic3r) August 21, 2013 10:58AM |
Registered: 12 years ago Posts: 127 |
Re: First layer / callibration issue (Prusa i3 - Slic3r) August 21, 2013 04:02PM |
Registered: 10 years ago Posts: 46 |
Re: First layer / callibration issue (Prusa i3 - Slic3r) December 18, 2013 02:01PM |
Registered: 10 years ago Posts: 1 |
Re: First layer / callibration issue (Prusa i3 - Slic3r) December 18, 2013 04:29PM |
Registered: 10 years ago Posts: 10 |
Re: First layer / callibration issue (Prusa i3 - Slic3r) December 21, 2013 03:33AM |
Registered: 10 years ago Posts: 17 |
Re: First layer / callibration issue (Prusa i3 - Slic3r) March 27, 2015 04:07PM |
Registered: 9 years ago Posts: 1 |
Re: First layer / callibration issue (Prusa i3 - Slic3r) March 27, 2015 06:27PM |
Registered: 10 years ago Posts: 1,401 |
Re: First layer / callibration issue (Prusa i3 - Slic3r) March 27, 2015 07:43PM |
Registered: 9 years ago Posts: 182 |
Re: First layer / callibration issue (Prusa i3 - Slic3r) April 01, 2015 08:31PM |
Registered: 10 years ago Posts: 19 |
Re: First layer / callibration issue (Prusa i3 - Slic3r) April 02, 2015 01:44AM |
Registered: 11 years ago Posts: 1,171 |
Quote
Just cant get Z to go down below zero at home posistion
i can change the z offset to -1 or sobut does not move.
Re: First layer / callibration issue (Prusa i3 - Slic3r) April 02, 2015 01:49AM |
Registered: 11 years ago Posts: 1,171 |
Re: First layer / callibration issue (Prusa i3 - Slic3r) April 02, 2015 05:20PM |
Registered: 10 years ago Posts: 869 |
Re: First layer / callibration issue (Prusa i3 - Slic3r) April 04, 2015 10:50PM |
Registered: 9 years ago Posts: 29 |
Re: First layer / callibration issue (Prusa i3 - Slic3r) January 09, 2016 11:03AM |
Registered: 8 years ago Posts: 1 |
Re: First layer / callibration issue (Prusa i3 - Slic3r) January 09, 2016 11:48PM |
Registered: 10 years ago Posts: 444 |
Quote
The default width for the first layer was 200% (of normal extrusion width). In my opinion this should be set to 100%, or slightly more if it's really necessary.
Re: First layer / callibration issue (Prusa i3 - Slic3r) September 14, 2017 04:36AM |
Registered: 8 years ago Posts: 19 |