Printing with Repetier, settings inside Repetier set in Slic3r.
Firmware: Marlin
Slic3r 0.9.9
Marlin V1
I have now turned off 'generate support' to see if the same happens.
8:22:08 PM: Printing layer 1 of 100
8:25:26 PM: Printing layer 2 of 100
< 8:26:51 PM: Error:Line Number is not Last Line Number+1, Last Line: 3588
< 8:26:51 PM: Resend: 3589
8:26:51 PM: Resend: N3589 G1 X111.62 Y82.35 F7800.00 *64
8:26:51 PM: Resend: N3590 G1 E0.9000 F1800.00 *4
< 8:26:51 PM: Error:Line Number is not Last Line Number+1, Last Line: 3588
< 8:26:51 PM: Resend: 3589
8:26:51 PM: Resend: N3589 G1 X111.62 Y82.35 F7800.00 *64
< 8:26:51 PM: Error:No Line Number with checksum, Last Line: 3588
8:26:52 PM: Resend: N3590 G1 E0.9000 F1800.00 *4
8:27:11 PM: Printing layer 3 of 100
Ended up like the picture in the attachment..
Edit:
Apparently, when I turn off 'Enforce support material for # first layers' the error disappears.
But still, I need to print it with support for the first 7 layers...
When I disable the support generation, the print also goes from 100 to 99 layers. So maybe it generates a bogus layer somehow...?
Edited 2 time(s). Last edit at 04/30/2013 02:57PM by Ohmarinus.