Hello
I spent all day trying to get my Rostock Max doing some decent prints changing settings reprinting etc.
Using the Rambo board 1.0e
I've only been running it for UNDER 1 month.
Now suddenly my Rambo isn't noticed in my serial ports
The Green light by the USB goes on but nothing else.
Repetier and Arduino can't connect.
Mac USB port calls it "AVR DFU Bootloader", Product ID: 0x2ff0 Version: 0.00 Vendor ID: 0x03eb ( Amtel Corporation)
Same thing in PC, when I load the rambo driver file it says it's not used by this device and can't upload anything!
What can I do? I've been waiting a while and nothing on replacement or anything from seller and I'm getting very ancy.
Is there any way I can connect to it directly and upload the software as it seems to have somehow erased everything from it.
I've been trying for almost a week now.
thank you in advance
A
Edited 1 time(s). Last edit at 02/16/2013 11:31PM by truenorthtrader.
