Yea no issues with the power supply or plug that I can find.
Checked from ground to vmot and im getting 12v on all the drivers.
Checked from ground to vdd and its switching between 4.7v and 3.6v every couple seconds.
Checked both motor groups with no voltage on either pair.
Checked ground to dir and it was switching between high and low states as it should.
Checked ground to enable pin no voltage.
I also noticed that one mosfet output wasn't toggling like it should so I think that mosfet is dead as I checked the control pins for each and they are going high then low like they should. So new ramps board will be ordered.
Edited 1 time(s). Last edit at 02/11/2018 10:34AM by hcker2000.