Welcome! Log In Create A New Profile

Advanced

z probe ignored

Posted by huskies62 
z probe ignored
January 20, 2018 11:30AM
I have a NPN probe for leveling. It shows at triggered but does not stop movement in either direction. It shows as triggered when it should and open when it should. Running ramps 1.4 on a Anet A8. Any help would be greatly appreciated

Edited 1 time(s). Last edit at 01/20/2018 11:31AM by huskies62.
Re: z probe ignored
January 20, 2018 12:11PM
Have you install new firmware or it this a stock machine. More information may assist us in helping you.
Re: z probe ignored
January 20, 2018 04:04PM
Oops sorry. I have installed Marlin 1.1.8
Re: z probe ignored
January 20, 2018 04:25PM
What settings do you have for your Mechanical end-stops "COM to ground and NC to Signal uses "false" here (most common setup)"
Re: z probe ignored
January 20, 2018 08:20PM
I finally got it. I had to home it. I either missed that or didn't get to that part of the instructions. Thanks for at least trying to help smiling smiley
Sorry, only registered users may post in this forum.

Click here to login