Welcome! Log In Create A New Profile

Advanced

Noise from Y motor on CoreXY

Posted by kendler 
Noise from Y motor on CoreXY
December 14, 2017 01:14PM
I've built a CoreXY printer (HyperCube) a few months ago
Not sure why, I've always had a very loud noise when moving, caused by the Y motor vibrating and thus vibrating the entire frame
I've tested a different Motor/Drive/RAMPs board - result is the same. motor is vibrating (can feel it when the motor is in my hand)
Same with Marlin 1.1.4/5/6

Any ideas what can be the cause of that?
Re: Noise from Y motor on CoreXY
December 15, 2017 01:17AM
Just for fun you could define a different printer type and see, if it's a firmware problem with CoreXY kinematics.
Re: Noise from Y motor on CoreXY
December 15, 2017 01:46AM
Good idea.
I've tried. same story - Y motor is noisy
Re: Noise from Y motor on CoreXY
February 03, 2018 02:43PM
Did you check the voltage? Should be around .650 vdc
Sorry, only registered users may post in this forum.

Click here to login